

Injection-packers are recommended for the injection of one-component and two-component resins for concrete structure waterproofing and concrete crack repair (epoxy, PU and PUR polyurethane, acrylate, etc.).
Injection packer suitable for 14mm boreholes
Injection-packers are recommended for the injection of one-component and two-component resins for concrete structure waterproofing and concrete crack repair (epoxy, PU and PUR polyurethane, acrylate, etc.).
Injection packer suitable for 14mm boreholes
Rubber part outer diameter: 12.8mm (use a 14mm SDS drill)
Internal diameter of the injection packer: 2.5mm
Internal diameter of the grease nipple part: 1.8mm
Total length: 110MM
Connection type: grease nipple
Non-return system: Metal ball in the grease nipple
Material: steel + aluminum
Pressure 20 to 250 BAR (note the maximum pressures indicated may vary depending on the type of support and its condition.)
Packaging: 100 units
Install the injection-packer in the 14mm drilled hole with the whole rubber part inside the support.
Screw the packer (M6) to inflate its sealing rubber and ensure that the injector is held in the hole.
Connect the pump with a grease nipple coupling to the mechanical injection packer and inject.
After the injection, the sealing rubber part remains in the borehole. The other part can be removed either by breaking it with a hammer or by unscrewing it.
Diameter 10mm Ref 01090100
Diameter 14mm Ref 01090101